Chimera V2 CNC Clutch Lifter Plate

Chimera V2 CNC Clutch Lifter PlateChimera Engineering V2 CNC clutch pressure plate is made from T 6061 aluminum! Chimera clutch plate is a direct replacement from the weak cast aluminum OEM unit that generally breaks when stiffer clutch springs are installed. The V2 version has been improved to handle up to 80% clutch springs! Perfect for all types of riding, from stunt, racing, to cruising! Highly recommended for those who are planning to run stiffer clutch springs, the increased

Made in Australia

Photo shows the clutch pack that is NOT included

The Uppercut gas cap is a knockout design with highly detailed machine work and finish

Speed Controller bracket bolts (oem controller)

and air filter

It makes crankcase disassembly easy by safely pushing the crank assembly out of the case halves

Overall length - 31 inches or approximately 787mm

All stitching is double stitched with square/cross with heavy duty nylon thread

which can cause the engine to over-rev by pushing it through its REDLINE

165" exhaust cam lift

Two-point support crankshaft

If you have a 132cc kit then you should consider running the Keihin PE24 or the more cost friendly Mikuni VM26